Every ONU on a GPON or EPON network reports how much light it receives from the OLT. This number, the Rx optical power, is measured in dBm and is the single most useful figure for finding fibre problems before customers notice them.
Rx and Tx in plain words
- Rx power (ONU): how strong the light from the OLT is when it reaches the customer's ONU.
- Tx power (ONU): how strong the light the ONU sends back is.
- Rx at the OLT: how much of the ONU's light arrives back at the OLT.
The values are negative, so -20 dBm is a stronger signal than -26 dBm.
What healthy looks like
Exact limits depend on the optics and the PON class used by your equipment, so always check your OLT and ONU datasheets. As a practical rule of thumb used by many ISPs:
| ONU Rx power | What it usually means |
|---|---|
| Around -8 to -24 dBm | Normal working range for most PON networks |
| Around -25 to -27 dBm | Weak; the link works but has little margin left |
| Below about -27 dBm | Too weak; drops, slow speed or no connection are likely |
What causes weak signal
- Dirty or badly fitted connectors, the most common and cheapest problem to fix.
- Tight bends in drop cables inside walls or around poles.
- Poor splices or a damaged splitter.
- Too many splits or a long distance on one PON.
- Rodent damage or stress on overhead cables.
From complaints to planned maintenance
A customer whose Rx drops from -21 to -26 dBm over two weeks has not complained yet, but will soon. When an ISP watches optical power for every ONU and sorts by "getting worse", field teams can fix connectors and bends during planned visits instead of after an angry call. When many ONUs on the same port weaken together, the fault is upstream, at a splitter or feeder cable.
How OLTCare helps
OLTCare collects optical power for every ONU across all your OLTs, shows it next to online status, and flags ONUs with weak signal and fibre-down events. Support staff see the reading during a call; engineers see which areas need work. Read the full overview in OLT management software.